Pass4itsure Cisco (CCNA, CCNP, Meraki Solutions Specialist, CCDP…) dumps updates throughout the year and share some exam questions for free to help you 100% pass the exam

How to prepare for Cisco CCNA 200-301 exam to obtain certification in a short period of time

Prepare for your Cisco (CCNA) certification with the updated Pass4itSure CCNA 200-301 exam questions. Pass4itSure provides 200-301 VCE or PDF for the Cisco 200-301 test to help you quickly prepare for the Cisco Certified Network Associate exam. Complete CCNA 200-301 exam questions answers (Total Q&As: 598).

Download free 200-301 PDF for Cisco 200-301 test

[latest CCNA 200-301 pdf] free CCNA 200-301 PDF From Drive, provided by Pass4itSure

Cisco CCNA 200-301 test free [200-301 questions answers q1-q15]

Which function does an SNMP agent perform?
A. It sends information about MIB variables in response to requests from the NMS
B. It manages routing between Layer 3 devices in a network
C. It coordinates user authentication between a network device and a TACACS+ or RADIUS server
D. It requests information from remote network nodes about catastrophic system events
Correct Answer: A

What is a similarly between 1000BASE-LX and 1000BASE-T standards?
A. Both use the same data-link header and trailer formats
B. Both cable types support LP connectors
C. Both cable types support Rj-45 connectors
D. Both support up to 550 meters between nodes
Correct Answer: A

Which type of attack is mitigated by dynamic ARP inspection?
B. malware
C. man-in-the-middle
D. worm
Correct Answer: C

What does physical access control regulate?
A. access to spec fie networks based on business function
B. access to servers to prevent malicious activity
C. access 😮 computer networks and file systems
D. access to networking equipment and facilities
Correct Answer: D

How do traditional campus device management and Cisco DNA Center device management differ in regards to
A. Traditional campus device management allows a network to scale more quickly than with Cisco DNA Center device
B. Cisco DNA Center device management can deploy a network more quickly than traditional campus device
C. Cisco DNA Center device management can be implemented at a lower cost than most traditional campus device
management options.
D. Traditional campus device management schemes can typically deploy patches and updates more quickly than Cisco
DNA Center device management.
Correct Answer: B

On a corporate network, hosts on the same VLAN can communicate with each other, but they are unable to
communicate with hosts on different VLANs. What is needed to allow communication between the VLANs?
A. a router with subinterfaces configured on the physical interface that is connected to the switch
B. a router with an IP address on the physical interface connected to the switch
C. a switch with an access link that is configured between the switches
D. a switch with a trunk link that is configured between the switches
Correct Answer: A
Different VLANs can\\’t communicate with each other, they can communicate with the help of Layer3 router. Hence, it is
needed to connect a router to a switch, then make the sub-interface on the router to connect to the switch, establishing
Trunking links to achieve communications of devices which belong to different VLANs.

Which CRUD operation modifies an existing table or view?
A. read
B. create
C. replace
D. update
Correct Answer: D

Router R1 must send all traffic without a matching routing-table entry to Which configuration accomplishes
this task?
A. R1#Config t R1(config)#ip routing R1(config)#ip route default-route
B. R1#Config t R1(config)#ip routing R1(config)#ip route
C. R1#Config t R1(config)#ip routing R1(config)#ip route
D. R1#Config t R1(config)#ip routing R1(config)#ip default-gateway
Correct Answer: C

Refer to the exhibit. When PC-A sends traffic to PC-B, which network component is in charge of receiving the packet
from PC-A verifying the IP addresses, and forwarding the packet to PC-B?

200-301 exam questions-q9

A. Layer 2 switch
B. Router
C. Load balancer
D. firewall
Correct Answer: B

What is a function of Wireless LAN Controller?
A. register with a single access point that controls traffic between wired and wireless endpoints.
B. use SSIDs to distinguish between wireless clients.
C. send LWAPP packets to access points.
D. monitor activity on wireless and wired LANs
Correct Answer: C
Lightweight APs (LAPs) is devices require no initial configuration. LAPs use the Lightweight Access Point Protocol
(LWAPP) to communicate with a WLAN controller (WLC), as shown in the below figure. Controller-based APs are useful
in situations where many APs are required in the network. As more APs are added, each AP is automatically configured
and managed by the WLC.

200-301 exam questions-q10

Which action does the router take as rt forwards a packet through the network?
A. The router replaces the source and desinaoon labels wth the sending router uterface label as a source and the next
hop router label as a desbnabon
B. The router encapsulates the source and destination IP addresses with the sending router P address as the source
and the neighbor IP address as the destination
C. The router replaces the original source and destination MAC addresses with the sending router MAC address as the
source and neighbor MAC address as the destination
D. The router encapsulates the original packet and then includes a tag that identifies the source router MAC address
and transmit transparently to the destination
Correct Answer: C

Which device performs stateful inspection of traffic?
A. firewall
B. switch
C. access point
D. wireless controller
Correct Answer: A

Which two goals reasons to implement private IPv4 addressing on your network? (Choose two.)
A. Comply with PCI regulations
B. Conserve IPv4 address
C. Reduce the size of the forwarding table on network routers
D. Reduce the risk of a network security breach
E. Comply with local law
Correct Answer: BD

Which configuration is needed to generate an RSA key for SSH on a router?
A. Configure VTY access.
B. Configure the version of SSH.
C. Assign a DNS domain name.
D. Create a user with a password.
Correct Answer: C

An office has 8 floors with approximately 30-40 users per floor. What command must be configured on the router
Switched Virtual Interface to use address space efficiently?
A. ip address
B. ip address
C. ip address
D. ip address
Correct Answer: B
need ip count: 30-40 * 8 = 320 ip – 510 ip

If you are interested in reading more information about the answers to the CCNA 200-301 exam questions, please click Trust Pass4itSure to help you learn, prepare, and practice for CCNA 200-301 exam success.

latest CCNA 200-301 pdf free here